![]() ![]() my tablet is plugged into a usb port 3: is there any problem already reported on this?Ģ. ![]() This should probably be linked to the calibration problem.Īll this leads me to think if these problems are due to some factors:ġ. ![]() I deactivated the automatic rotation and the lag with the symmetry tool improved a little bit.īut the problem of needing to touch the table to change the tool (when I alternate tools with the circle of tools) still persists. I also made several changes to the settings without success. I reinstalled the driver but it did not work. But this only happens in this new version and only with the pen, because with the mouse, all the tools work well and in the previous version (6.2.7), even with the pen everything works well. I noticed that, with the pen only, the cursor has a certain spacing showing a calibration problem: while the cursor is almost halfway down, the image that appears at the zoom is referring to the top. I copied and pasted several images and tried to capture the color through the color pick keeping the pen in the tablet and dragging to check the colors. it recognize all the screens, but with this problem in calibration. I noticed the problem with the pen that recognizes only 1/3 of the screen is referring to calibration. Unfortunately enough to make me go back to the previous version, as it was impracticable to continue wasting time with this newer version. These were the main problems I have encountered so far. It is bad because it ends up being unfeasible for small details. When I activate the tool, and try to draw in perspective, the program takes time to recognize the movements. The pen suffers a certain lag when I use the perspective tool. I already uninstalled and reinstalled, removed the registry keys, but nothing helped.ģ. I already tried to change the configuration of both the program and the video card, but it does not solve. I can capture the colors on any monitor, inside or outside the program, but within the program, this is limited to a fraction of the monitor, close to 1/3 ~ 1/2. Although it opens across the screen (1680x1050) it seems that it only works and recognizes one, approximately. Dragging along the image, you can see how far the program recognizes the image, This occurs only horizontally. ![]() This is clear when I paste an image and I try to capture the color with the pick color. This problem with monitor resolution: I noticed that the software does not recognize the correct display resolution of both the secondary monitor and the primary monitor. There is also a certain lag in the selection of tools.Ģ. It was not necessary to touch the tablet to make the selection. Before I just activated the circle of tools and placed the cursor on the desired tool. I need to touch the tablet (Wacom bamboo) to select the tool, which was not necessary in the previous version. I have been trying to solve these problems for last 3 days, but I didn´t find the solution.ġ. It was helping a lot, but this new version, despite the new tools that would help a lot, only brought me problems. I make diagrams, mental maps, class notes, etc. With this, I no longer need paper and still have the advantage of being able to load almost everything on a pen drive. I am a student and I decided to use it to make my summaries. A few days ago I realized that the software became free so I decided to upgrade. I was using Sketchbook Pro 6.2.7 and it was working wonderfully well. Here I am experiencing some problems with this, too. Go to Preferences and deactivate "Enable Rotate Canvas" on General Tab. It seems that there is some problem in this and he does not recognize very well the resolution of some monitors.ī. If that does not work, check the resolution that the software recognized from your monitor. After testing, return to the previous setting and try again. warning so before doing this, place all tool windows in the center to prevent them from getting lost with the resolution of the other monitor. Try to invert the order of your monitors and run a test (1-> 2 and 2-> 1). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |